banner



Can I Repair A Blown Speaker In An Ion Block Rocker

ION Audio Job Rocker - FAQ and Troubleshooting

ion job rockerThe ION Job Rocker provides powerful on-the-get audio in a rugged, rechargeable package.  In this article, we'll comprehend answers to frequently asked questions, and bones troubleshooting tips.

Frequently Asked Questions

  • My Task Rocker is not charging.  What should I do?
  • I'chiliad having trouble pairing my Bluetooth sound device (i.e. phone) to the Job Rocker, what should I practise?
  • How can I replace the internal battery?
  • How long does does it take to accuse the bombardment?
  • How long will a fully charged battery terminal?
  • Is the Job Rocker waterproof?
  • What are the rubber covers over the A/C outlets at that place for?
  • Tin the Job Rocker charge my iPod/iPhone?
  • There is no Mic connection on the Job Rocker.  Tin can I connect a mic to the AUX IN port?
  • How far can the Bluetooth connexion go?
  • Do the A/C outlets work if the Job Rocker is running on battery power?
  • The sound is coming out distorted.  What is happening and how can I fix it?
  • I get feedback when I utilise a microphone. How can I forbid this?
  • I'm getting poor AM reception. What can I do?
  • Tin can the Job Rocker be used in a foreign country?
  • I need further support or warranty service.  Who can I contact?

My Job Rocker is not charging.  What should I do?

This symptom could be acquired by a burned out Fuse.  To determine if a burned out fuse is the potential cause of your battery not charging, connect the Job Rocker to a ability source and look at the level meters on the dorsum of the Chore Rocker.

If the Charging Lite is lit, information technology means that the Job Rocker is currently charging and the fuse is not burnt out.  Nonetheless, if the battery is fully charged, the Charging Low-cal will non lite upwards.

If the Battery Level lights are less than completely full and the Charging Lite is non lit while the Job Rocker is connected to a power source, and then the fuse is likely burnt out.  You can follow the steps suggested below to replace a burnt out fuse.

  1. Disconnect your production from whatever power sources, and remove the IEC ability cablevision.
  2. Locate the fuse door adjacent to the IEC ability cable port on the rear of the product.

    ion job rocker fuse location

  3. Advisedly open the fuse door using a flat-head screwdriver.

    ion job rocker fuse door

  4. Audit the fuse to see if it has burned out.

    ion job rocker fuse

  5. If the fuse has burned out, replace with the following:
    • 110V regions (i.eastward. United states) - 750mA/250V
    • All other voltage regions - 315mA/250V
  6. If the fuse has not burned out, the battery may crave replacement.  Please refer to the following commodity:
    • Battery Replacement

I'g having problem pairing my Bluetooth audio device (i.e. phone) to the Job Rocker, what should I do?

Nearly pairing issues can be quickly resolved past following the suggestions in the following guide:

  • Tips for pairing your Bluetooth speaker to a compatible device

How can I replace the internal battery?

 If your battery requires replacement.  Please refer to the following article:

  • Battery Replacement

How long does does information technology take to charge the battery?

It takes approximately x hours to accuse the Job Rocker battery from empty to full.

How long will a fully charged battery last?

A fully charged Task Rocker battery can last up to 50 hours at a reasonably loud indoor listening volume.  Bombardment life may vary based on temperature, age, and book usage.

Is the Job Rocker waterproof?

The Job Rocker is dust-proof, simply not h2o-proof.  The condom covers located over the A/C adapter connections are intended to forbid debris such as dust, saw-dust, and clay from inbound and are not water-proof covers.  The rubber dust-covers are not user-replaceable parts.

Tin can the Job Rocker charge my iPod/iPhone?

The Job Rocker does not contain an iPod dock or charging station.  Most people utilize the AUX IN port in society to connect their iPod/iPhone and listen to stored music through the Job Rocker.

There is no Mic connexion on the Job Rocker.  Tin can I connect a mic to the AUX IN port?

The Task Rocker has an one/eight inch Aux port.  This Aux port is meant to be connected to a powered source such every bit a phone or tablet.  You will be able to get a microphone connected if yous apply some kind of mixer or pre-amp device but a mic connected directly will not perform properly.  Withal, this port is a line-level input not specifically intended to exist used with a mic, so the level of the mic volition most likely be lower than a typical sound source such as an iPod or iPhone.

How far tin the Bluetooth connection go?

The range of the Bluetooth connectedness of a Job Rocker is upward to 100 feet - equally long as the transmitting sound source is not moving around, in that location are no obstructions between the sound source and the Task Rocker, and it is non in a pocket or covered in any way.  The range can besides exist affected by the Bluetooth chipset in the sound source equally well.

Do the A/C outlets work if the Job Rocker is running on battery power?

No.  If yous are not receiving power from the A/C outlets located on the rear of the Task Rocker, ensure that the product is connected to a ability source.  If the Job Rocker is plugged in and you are still not receiving ability from the A/C outlets, you may potentially have a blown fuse.  To determine if a fuse is the cause of this symptom, click here.

The sound is coming out distorted.  What is happening and how can I fix it?

If the sound from your Task Rocker is coming out distorted, try lowering the book control of your sound source - such as your iPod or iPhone.  Also, try reducing the overall book of the Job Rocker.

If you go on to experience sound issues subsequently following the steps suggested above, yous may want to contact ION Tech Support.

I get feedback when I use a microphone.   How can I foreclose this?

There are a few piece of cake steps yous tin take that can help reduce the likelihood of feedback.  Check out the following article to learn more:

  • Tips for reducing feedback when using a microphone with a speaker, amplifier or PA

I'k getting poor AM reception.  What tin I exercise?

If you take a Bluetooth device connected to the Chore Rocker and you lot are listening to AM radio, disconnected the Bluetooth device and the AM frequencies will probable clear up.  To proceed to adapt AM reception, move the entire unit.  Sometimes there is a slight operating dissonance around the 540 kHz AM frequency, only other than that, typical adjustment of the position of the production should help articulate up any poor reception.

Can the Job Rocker be used in a strange country?

The Job Rocker can only be used in the state for which information technology was designed to be used.  It cannot exist adjusted for apply in a country with a different electrical current than it was manufactured to exist used with.

Technical Support & Warranty Service

Whether you lot are a customer or dealer, if you already own a ION production, or if you lot just accept pre-sales questions, the experienced ION technical support team is available to help!

Visit the link below to connect with whatsoever of the following back up options: online community support, phone support, electronic mail support.

  • world wide web.ionaudio.com/support

Source: https://www.noterepeat.com/products/ion/portable-audio/174-ion-job-rocker-faq-and-troubleshooting

Posted by: beckerdowen1969.blogspot.com

0 Response to "Can I Repair A Blown Speaker In An Ion Block Rocker"

Post a Comment

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel